Cast Iron Boilers

 

Biasi B10 Boiler

 

The Biasi B10 Series Oil & Gas Fired Boiler

The B-10 boiler systems have been heating residential and commercial buildings throughout the world for years. It has proven its fuel efficiency and durability in countries where fuel can cost up to four times as much as in the U.S. The same fuel saving technology is now available here in North America. With the three pass boiler design and low water content, heat is quickly supplied for your heating zones and hot water needs. Combined with an outdoor reset control, you can achieve a fuel savings of up to 40% over conventional single pass boilers. You will also have peace of mind since the B-10 boiler package complies with ASME and UL standards and is IBR rated. The B-10 boiler system is the cost-competitive heat and hot water system of choice.

Technical Advantages

  • Gas or oil burner compatible
  • Easy access swing door
  • No flue required; can be direct vented outdoors
  • Low water content boiler heats up faster with less fuel
  • Efficient 3-pass heat exchanger boiler design
  • GG20 cast-iron construction for superior heat retention and durability
  • ASME, UL, and IBR listed
  • 58 psi cast-iron construction

 

Biasi b10 3-Pass Diagram

Specs with Oil Burner

Boiler Model #
Heating capacity
Gross Input Burner Capacity
Net Output (MBH)
AFUE Efficiency (%)
Water Content (Gals.)
Length (L) (Inches)
Weight (Lbs.)
   MBH
G.P.H.
           
B-3
67
0.55
 
58
86.6
3.7
15.5
247
B-4
97
0.80
 
84
85.8
4.7
19.5
307
B-5
124
1.00
 
108
87.2
5.7
23.5
367
B-6
153
1.25
 
133
86.7
6.7
27.5
427
B-7
185
1.50
 
161
86.8
7.7
31.5
486
B-8
211
1.80
 
183
86.8
8.7
35.5
546
B-9
257
2.10
 
223
86.5
9.7
39.5
606

Maximum water working pressure: 58 PSI. (1) The burner input is based on oil with a heat value of 140,000 BTU/Gal.; (2) The net output ratings shown are based on piping and pick-up allowance of 1.15; (3) The efficiency ratings are based on a combustion condition of 12.5% CO2. Warranty: The BIASI B-10 boiler has a limited lifetime warranty. A copy is provided with each boiler or is available from your dealer. Built in accordance with the requirements of ASME boiler and pressure vessel code.

 

Specs with Gas Burner

Boiler Model #
Heating capacity
 Gross Input Burner Capacity
Net Output (MBH)
AFUE Efficiency (%) Chimney
Water Content (Gals.)
Length (L) (Inches)
Weight (Lbs.)
   MBH
MBH
         
B-3
67

80
60
84.4
3.7
15.5
247
B-4
97

112
84
84.0
4.7
19.5
307
B-5
124

140
103
83.8
5.7
23.5
367
B-6
153

175
129
83.6
6.7
27.5
427
B-7
185

215
157
83.0
7.7
31.5
486
B-8
211

257
189
83.6
8.7
35.5
546
B-9
257

298
219
83.5
9.7
39.5
606

Maximum water working pressure: 58 PSI.  Maximum Relief Valve is 30 psi at 500 MBH

Contact Us for a Free Estimate from a Local Dealer

 

Biasi Boilers and Radiators logo

Small Boilers = Huge Savings!

BIASI Delivers Proven Reliability & Savings

When Peter Hickey of Hickey & Lynk Burner Service of Dominion, NS tells customers he is going to help them save on their heating costs, he really delivers, and does so using BIASI boilers. Peter is installing BIASI boilers all over Cape Breton, NS and customers are reducing their fuel bills by up to 50%*!  Check out a couple of Hickey & Lynk’s customers who have cut their fuel bills using BIASI boilers.


Glace Bay Customer with Biasi B10 Boiler

Sandy From Glace Bay

SAVES 50% with BIASI 

When looking to replace his old locally made boiler, Sandy was told by a local fuel supplier that it was impossible to save 40% with any boiler!  BIASI proved them wrong by cutting Sandy’s fuel consumption from 2,800 litres per year to 1,400 litres.  By choosing a BIASI, Sandy cut his fuel consumption in half and saved over $1,100 in only ONE YEAR!

Home saved 50% on heating bill

Home saved 40% on heating Bill

Emilio from Cape Breton

SAVES 40% with BIASI 

When Emilio decided to have a BIASI boiler installed in his home, he had no idea of just how much money he would save!  With the old boiler he used 4,275 litres per year to heat his home.  Now, his new BIASI boiler only uses 2,623 litres to heat his home.  Emilio admits that he almost “cut my fuel bill in half!” 

Installer and Customer with New Biasi B10 boiler

BIASI Delivers Proven Reliability & Savings!

BIASI boiler systems have been installed in residential and commercial buildings throughout the world for years.  Designed and manufactured in Europe, where the prices for fuel oil can be four times what we pay in Canada, BIASI boilers have provided proven savings for many years.

Biasi Boiler & Radiators Logo

 BIASI 3-Pass Design Saves Fuel!

The BIASI B-10 has a unique triple pass cast iron heat exchanger that extracts the maximum amount of heat from the combustion gasses, resulting in very little wasted heat and super high efficiency.  The BIASI B-10’s heat exchanger path is 7.3feet long versus 1.5 feet for a single pass, “pin-type” boiler, resulting in a greater heating surface area and 50% less heat loss up the chimney.

 * Results vary with each installation. 

Biasi B10 3pass design diagram

Click here to download a PDF version of this Case Study

 

Biasi Boilers and Radiators logo

Saint Dunstan's University Modernizes The

"Bishops Palace" a Charlottetown Landmark

Saint Dunstans University New Home of Biasi boiler

“On April 8, 2008, Saint Dunstan's University officially took possession of the Saint Dunstan's Basilica Rectory, formerly known as the "Bishop's Palace" after completing their purchase of it from Saint Dunstan's Basilica Parish. In February 2009, the SDU Board began extensive renovations to the building. In the process of the renovations, new heating, electrical, and plumbing systems were installed, as well as all new windows and a new slate roof. Efforts were made to retain the traditional architecture in the parlour, dining room, and hallway of the first floor; otherwise the building was entirely gutted and internally reconfigured.

SDU Place is a landmark in Charlottetown, PEI. It is shown here after extensive renovations.

 

The building, now renamed SDU Place, was officially opened October 8, 2009. The purchase of the "palace" by the SDU Board maintains a link that has existed for over 150 years between Saint Dunstan's University and the Saint Dunstan's Rectory.”*

 

Saint Dunstan’s University Wisely Chooses BIASI Boilers
When Saint Dunstan's University was looking for new boilers in their heating system, they were careful to consider all the options available.  They investigated both the initial installation and operational costs of the boiler system.  The cost of heating is one of the largest on-going expenses for a large building.  Wisely, they decided on BIASI B-10 cast iron boilers as the heart of their new heating system.

 *Excerpt taken from www.saintdunstansuniversity.ca
 

Glen Gardiner, of Mr. Plumber, standing beside two newly installed BIASI B10 9 Section boilers that are the heart of the heating system at SDU Place.

Installer with New Biasi B10 Boilers


Biasi B10 3pass design diagram BIASI 3-Pass Design Saves Fuel!

The BIASI B-10 has a unique triple pass cast iron heat exchanger that extracts the maximum amount of heat from the combustion gasses, resulting in very little wasted heat and super high efficiency.  The BIASI B-10's heat exchanger path is 7.3feet long versus 1.5 feet for a single pass, “pin-type” boiler, resulting in a greater heating surface area and 50% less heat loss up the chimney.

 

Click here to download a PDF Version of this Case Study

 

Biasi Boilers and Radiators logo

Biasi Teaches Elementary School How to

Save BIG on their Heating Budget

Boiler Case Study Installation Location Boiler Case Study Control System

Ecole Saint-Jean Bosco

Daniel Richer of Richer Commercial Heating stands in front of Ecole Sain-Jean Bosco French Catholic Elementary School where 206 students attend.  This is the latest location where Richer Commercial Heating has installed BIASI boilers.

The Brains of the Operation

Jean-Paul of Richer Commercial Heating shows the Heat Timer HWE Multi-Stage Boiler control that operates and sequences the four BIASI boilers.  Also, the HWE control provides for outdoor temperature reset and domestic hot water priority.

 

Out with the Old, In with the New

Jean-Paul of Richer Commercial Heating is pictured here with four new BIASI B-10 9 Section boilers with Heat Wise SU-3 gas burners. Ecole Saint-Jean Bosco had two massive, inefficient boilers which had been installed when the building was built in 1960.  Richer Commercial has since reported to us first year savings of 38% from their extremely satisfied customer.

B10 Gas Boiler Installation

 

Biasi B10 3pass design diagram BIASI 3-Pass Design Saves Fuel!

The BIASI B-10 has a unique triple pass cast iron heat exchanger that extracts the maximum amount of heat from the combustion gasses, resulting in very little wasted heat and super high efficiency.  The BIASI B-10's heat exchanger path is 7.3 feet long versus 1.5 feet for a single pass, “pin-type” boiler, resulting in a greater heating surface area and 50% less heat loss up the chimney.

Click Here to Download Colour Literature of this Case Study